WeatherPrufe POLYURETHANE ENAMEL (Excl. White; Green; Asbestos)

R300.00R3,300.00

A premium grade Polyurethane-Alkyd based coating for Interior and Exterior applications. Superior abrasion and chemical resistance properties make this product ideal for the most demanding interior floor and wall applications.

Clear
SKU: WPPUE Category:
 

Description

ADVANTAGES

  • Very tough and hard wearing coating
  • Interior and Exterior applications
  • Highly washable
  • Able to be catalysed where necessary

 

SPREAD RATE

Spread rate is dependant on the porosity and profile of the substrate. Typically spread rates of 10 square metres per litre are achieved.

APPLICATION

Apply to suitably primed or sealed and DRY substrates.  Can be applied to previously painted surfaces.  Water-based paints can be over coated directly.  When over coating Gloss Enamel, it is necessary to sand the old coating down to an even, matt finish before applying this product.  MOISTURE LEVELS IN SUBSTRATE SHOULD NOT EXCEED 15%.

Can be used on cold room cement floor screeds where temperatures do not fall below 5˚C.

Cement: Walls
Prime unpainted friable masonry surfaces with WeatherPrufe Masonry Primer, allow to dry for 8 hours.  Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, at a spread rate of 10 sqm per litre, allowing a 6 hour drying time between coats.

Cement: Floors
Prime friable surface with WeatherPrufe Masonry Primer, allow to dry overnight.  Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, diluted 5% with mineral turpentine, at a spread rate of 10 sqm per litre, allow to dry overnight between coats.

To unprimed stable surface, apply one coat of WeatherPrufe Polyurethane Enamel, diluted 10% with mineral turpentine, allow to dry overnight.  Once dry, apply second coat of WeatherPrufe Polyurethane Enamel, diluted 5% with mineral turpentine, allow to dry overnight.  To maximize the life expectancy of the coating, applying a final third coat will increase the life expectancy of the coating.

Metal
Prime metal surface with WeatherPrufe Etch Primer and allow to dry for 6 hours.  Once dry, apply two coats of WeatherPrufe Polyurethane Enamel allowing a 6 hour drying time between coats.

Wood
Prime wooden surfaces with WeatherPrufe Wood Primer and allow to dry for 6 hours.  Once dry, apply two coats of WeatherPrufe Polyurethane Enamel, allowing a 6 hour drying time between coats

 

FULL CURING TIME:  36 HOURS (with ambient temperatures from prep, coating and curing not falling below 12 degrees Celsius)

Approved by the Wine Industry

Additional information

Volume

1 Liter, 5 Litres, 20 Litres

Reviews

There are no reviews yet.

Be the first to review “WeatherPrufe POLYURETHANE ENAMEL (Excl. White; Green; Asbestos)”

Your email address will not be published. Required fields are marked *